Configured for high-speed data processing in industrial automation systems, the Allen-Bradley 6180-FLIFHLHTJEZ SER B (6180-FLIFHLHTJEZ Industrial Computer) provides direct physical execution of control logic and human-machine interface applications.

Hardware Identification

The 6180-FLIFHLHTJEZ SER B is a member of the Allen-Bradley VersaView industrial computer series. It is designed to function as a dedicated compute node for control network platforms, offering high resistance to environmental ingress as specified by NEMA type 1, 12, 13, and 4X standards.

Hardware Specifications

Control Systems and Deterministic Networking

The unit is engineered to support seamless integration with Prototypical EtherNet/IP deterministic networks, maintaining data synchronization across distributed control systems. Firmware flash compatibility ensures that the operating system and drivers can be updated to accommodate evolving network protocol standards. The architecture supports efficient I/O density scaling, allowing for centralized management of disparate field controllers without degradation of the primary control bus communication velocity.

Ordering Information

• One (1) 6180-FLIFHLHTJEZ Industrial Computer unit.

• Mounting hardware and gaskets for NEMA sealing.

• Digital documentation and standard recovery media.

Installation Guidelines

• Enclosure Mounting: Ensure the enclosure panel is flat and rigid to maintain the NEMA 4X ingress seal integrity during mounting.

• Power Wiring: Utilize appropriately gauged cabling for 18-32 VDC input. Ensure common-mode noise suppression by using a dedicated isolated DC power supply.

• Grounding: Secure the computer chassis to a common machine ground using a low-impedance braided strap to mitigate high-frequency ground loops.

• Ventilation: Maintain a 5 cm air clearance around all sides of the unit to ensure passive thermal dissipation does not exceed component ratings.

• Port Protection: Use NEMA-rated covers for any unused communication ports to maintain IP/NEMA ingress protection ratings.

Frequently Asked Questions

• Is the 6180-FLIFHLHTJEZ capable of hot-swapping?

  No. Disconnect all power and communication cabling before performing hardware maintenance or module replacement.

• How is the NEMA 4X seal verified?

  The seal is verified by ensuring the provided gasket is correctly seated and the mounting fasteners are torqued evenly across the perimeter.

• What is the input current requirement during peak operation?

  The unit is rated for 12 A at peak load; ensure the upstream circuit breaker is sized to handle this demand without nuisance tripping.

• Does the unit support redundant power inputs?

  Consult the specific terminal wiring diagram provided with the unit, as power input capability is model-revision dependent.

• Can I upgrade the internal system RAM or storage?

  Hardware upgrades must be performed using authorized components to ensure the system maintains its thermal and mechanical specifications.

• How is the system restored in the event of software failure?

  Use the factory-provided recovery media to re-image the drive; ensure all critical configuration files are backed up externally prior to any re-imaging task.

• Why is an isolated DC power supply required?

  Isolated power prevents circulating ground currents between the computer and other industrial modules, which can cause erratic data behavior.

• What happens if the input voltage exceeds 32 VDC?

  Exceeding the 32 VDC limit will trigger the internal over-voltage protection and may result in permanent hardware damage.