Configured for direct DC voltage conversion in PLC and control cabinet networks, the Omron S8JX-P30024CD (S8JX-P30024 Switch Mode Power Supply) provides direct physical/electrical execution.

Model Matrix & Identification

• Base Series: S8JX Power Supply Line
• Power Rating: 300 W output capacity
• Voltage Rating: 24 VDC output execution
• Construction: Covered type chassis
• Mounting Structure: Standard DIN Rail attachment (CD suffix designation)

Technical Specifications

Deterministic Power Architecture & Network Compatibility

The S8JX series incorporates stable voltage delivery mechanisms to power internal backplane bus communications and field I/O density configurations across Ethernet-based automation architectures. Thermal management components maintain low ripple parameters during steady-state logic processing. Protection circuitry isolates downstream programmable logic controllers from primary line transients.

Delivery Package

• 1 x Omron S8JX-P30024CD Power Supply Unit
• 1 x DIN Rail Mounting Bracket Assembly (Pre-installed)
• 1 x Safety and Technical Instruction Leaflet

Mechanical & Wire Installation Rules

• Mounting Clearance: Maintain a minimum vertical gap of 30 mm above and below the chassis for ambient convection airflow.
• Wiring Torque: Secure input and output screw terminals to 1.0 N-m to 1.2 N-m to prevent loose contact overheating.
• Grounding Connection: Run a heavy-gauge PE wire directly to the protective earth terminal to guarantee EMI filtering performance.
• Conductor Sizing: Utilize stranded copper wire rated for at least 75 deg C to manage 14 A continuous load current.

Frequently Asked Questions

• What is the input voltage tolerance range for this power supply?

  The unit accepts a wide universal AC input voltage range between 85 VAC and 264 VAC at 50/60 Hz without manual tap switching.

• Does the unit support direct parallel operation for increased current output?

  Standard units do not support direct parallel connectivity for load sharing unless external isolation diodes are installed.

• What type of mounting hardware is required for cabinet installation?

  The CD designation indicates factory-fitted DIN rail mounting tracks designed to snap onto standard 35 mm symmetric top-hat rails.

• How does the internal overload protection respond during an overcurrent event?

  The overcurrent circuit enters an automatic inverted-time protective state when load current exceeds nominal 14 A operational thresholds.

• What thermal derating parameters must be applied at elevated ambient temperatures?

  Output load capacity decreases linearly when ambient operating temperatures rise above 45 deg C within enclosed control cabinets.

• Does this model include internal harmonic current suppression features?

  Integrated passive filter stages provide power factor correction and reduce harmonic distortion on the incoming utility line.

• What is the recommended terminal wire gauge for the 24 VDC load connections?

  Wiring should use stranded copper conductors rated from 14 AWG to 12 AWG to minimize voltage drop under full 14 A output load.

• How is the DC output voltage adjusted if line loss occurs across long field runs?

  A front-panel potentiometer provides a fine-tuning adjustment range typically between -10 percent and +15 percent of 24 VDC.