Configured for fieldbus communication execution in Advant S900 networks, the ABB BP910S 3KDE175831L9100 (BP910S PROFIBUS-DP Connector) provides direct physical/electrical execution.

Part Number Breakdown & Identification

• Base Model Designation: BP910S
• Factory Part Number: 3KDE175831L9100
• Hardware Classification: PROFIBUS-DP Connector
• Series Architecture: ABB Advant S900 I/O

Hardware Specifications

Profinet and Deterministic Network Integration

The unit provides physical layer interconnection for Profinet and EtherNet/IP deterministic networks, supporting high-speed backplane bus communication velocity structures within distributed node environments. Firmware flash compatibility checks ensure that connected interface modules correctly interpret bus traffic without packet collision or token loss. I/O density scaling relies on proper bus termination impedance matching to maintain signal integrity across long-run industrial fieldbus architectures.

Ordering Information

• 1 x BP910S PROFIBUS-DP Connector
• 1 x Installation Instruction Leaflet

Physical Setup and Grounding Protocol

• Rail Placement: Snap the connector unit securely onto the standard DIN rail adjacent to the corresponding S900 base module.
• Shielding Termination: Connect incoming fieldbus cable shielding directly to the integrated grounding clamp to mitigate electromagnetic interference.
• Terminal Verification: Ensure all screw or spring clamp terminals are tightened to appropriate torque ratings before applying bus power.
• Environmental Clearance: Verify that ambient cabinet temperatures remain within specified operational limits to prevent connector housing degradation.

Frequently Asked Questions

• Does this connector support active bus termination?

  The unit serves as a physical interface connector, with active termination dependent on switch settings and the specific position on the bus line.

• Can the connector be replaced while the network is powered?

  Hot-swapping fieldbus connectors can cause temporary communication drops on active nodes, so proper system segregation is recommended.

• What causes intermittent PROFIBUS communication errors?

  Loose shield grounding, improper cable termination, or degraded pin contacts typically cause reflection and packet loss.

• Is external power required for this connector?

  No, this is a passive interconnection element powered by the network signal lines and base unit interface.

• What wire size is compatible with the terminal entries?

  Standard industrial PROFIBUS solid or stranded copper communication cables fit the designated clamping area.

• How is proper seating verified during installation?

  An audible click and physical lock indicate that the connector is fully mated with the underlying base unit interface.

• Are special tools required for wiring?

  Standard wire strippers and a precision screwdriver are sufficient for preparing and securing the fieldbus conductors.

• Does the unit require firmware updates?

  Being a passive mechanical and electrical connector, no firmware or software configuration is required.