The Bently Nevada 330903-00-06-10-02-05, also cataloged as the 330903 Proximity Probe, operates as a dedicated hardware component for non-contacting vibration measurement on small-diameter shafts within 3300 NSv monitoring platforms. This transducer captures the relative displacement between the probe tip and the target, providing a precise RF output signal to the NSv Proximitor sensor for continuous rotor dynamics evaluation.

Model Configuration Matrix

• 330903: 3300 NSv 5 mm Proximity Probe

• 00: Unthreaded Length (metric)

• 06: Overall Case Length (metric)

• 10: Total Length (metric)

• 02: Connector Type (Miniature ClickLoc)

• 05: Agency Approval (Multiple approvals)

Hardware Specifications

Mechanical Monitoring & Eddy-Current Dynamics

The 3300 NSv system is specifically designed for small-target applications where standard 8 mm probes are physically constrained. Accurate performance requires precise eddy-current probe scaling to convert target movement into an electrical signal. During commissioning, gap voltage validation at the -10 VDC target is essential to maintain the linear range of the NSv Proximitor. Cross-talk suppression is achieved through strict adherence to minimum separation distances between probes, ensuring the 1 MHz carrier frequency remains free from induced interference.

Ordering Information

• 1 x 330903-00-06-10-02-05 Proximity Probe

• 1 x Connector protector

• Technical instruction documentation

Field Installation Guidelines

• Mechanical Mounting: Torque the mounting jam nut to established specifications to ensure stable contact with the machine casing.

• Side-View Clearance: Ensure a minimum clearance from the mounting hole wall to prevent peripheral interference with the electromagnetic field.

• Cabling: Use grounded metallic conduit for coaxial runs to mitigate environmental electrical noise and provide physical protection.

• Connector Integrity: Fully seat the ClickLoc coupling and secure the connector protector to prevent moisture ingress at the connection point.

• Signal Validation: Verify the gap voltage at the monitor terminal block before bringing the machine to operational speed.

Frequently Asked Questions

• Q: Can the 330903 probe be used with 3300 XL Proximitors?

  A: No. The 3300 NSv system has unique frequency response characteristics and is not compatible with standard 3300 XL probe electronics.

• Q: What is the benefit of the 5 mm tip?

  A: The 5 mm tip is optimized for smaller shafts and tighter physical installations where an 8 mm probe would be too large to detect the target accurately.

• Q: Can the probe be submerged in oil?

  A: Yes, the probe and its connector are designed for harsh industrial environments, including exposure to lube oil and synthetic lubricants.

• Q: How do I test the probe for failure?

  A: A functional probe displays a stable voltage within the expected range; an open or short circuit will cause the Proximitor to output a diagnostic fault signal.

• Q: Is the PPS probe tip fragile?

  A: While the PPS material is mechanically robust, it should not be subjected to direct impact or abrasive contact with the rotating shaft.

• Q: Does the target material affect calibration?

  A: Yes, calibration is based on 4140 steel. Other conductive materials will change the probe sensitivity and require a correction factor.

• Q: Why is the gap voltage target at -10 VDC?

  A: This value provides the optimal midpoint in the Proximitor's linear range, ensuring the system can accurately capture both positive and negative displacement.

• Q: Can the coaxial cable be extended beyond the factory length?

  A: No. The probe and cable are an integrated, factory-tuned resonant system; modifying the length destroys the system's accuracy.