Configured for high-frequency signal propagation within machinery protection networks, the Bently Nevada 330190-130-00-05, also cataloged as the 3300 XL Standard Extension Cable 3300 XL Standard Extension Cable, provides direct physical/electrical execution.

Catalog Nomenclature and Option Architecture

• Base Catalog Model: 330190
• Length Configuration Suffix: 130
• Cable Option Suffix: 00 - Standard cable
• Agency Certification Suffix: 05 - CSA, ATEX, IECEx Approvals
• Product Line Classification: 3300 XL Standard Extension Cable

Hardware Specifications Table

Rotor Dynamics and Signal Transmission Integrity

• Preserves accurate eddy-current probe scaling to guarantee linear displacement measurements across variable shaft rotational speeds.
• Facilitates precise gap voltage validation targeting standard -10 VDC baselines for machinery monitoring systems.
• Incorporates structural cross-talk suppression mechanisms to maintain signal fidelity in dense multi-channel installations.
• Minimizes phase distortion to support complex rotor dynamics analysis in high-speed turbomachinery.

Ordering Information

• 1 x Bently Nevada 330190-130-00-05 Extension Cable
• 1 x Hazardous Area Certification Documentation Sheet

Installation and Routing Guidelines

• Cable Routing and Mechanical Protection
  • Route the extension cable through dedicated conduits separated from high-voltage power lines to prevent induced electrical noise.
  • Secure the cable length securely at regular intervals to prevent mechanical fatigue caused by structural vibration.
• Environmental Sealing and Grounding
  • Ensure all threaded connector interfaces are fully mated and torqued to maintain environmental integrity.
  • Verify single-point shield grounding to eliminate ground loops in sensitive proximity measurement loops.

Frequently Asked Questions

• What is the specified output resistance of this extension cable?

  The output resistance is rated at 50 ohm.

• What is the typical capacitance of the extension cable?

  The extension cable capacitance is typically 69.9 pF/m (21.3 pF/ft).

• What material is specified for the associated probe case construction?

  The probe case is constructed from AISI 303 or 304 stainless steel (SST).

• What agency approvals are included with this specific part configuration?

  This model includes CSA, ATEX, and IECEx approvals.

• What is the physical weight of the packaged unit?

  The unit weighs approximately 0.25 kg.

• What are the estimated shipping dimensions?

  The estimated shipping dimensions are 20 x 20 x 2.5 cm.

• What is the country of origin for this hardware component?

  The country of origin is the USA, with shipment originating from Xiamen, China.

• Is this cable designed for standard or extended temperature ranges?

  This configuration corresponds to the standard extension cable design parameters.