The Bently Nevada 330104-00-05-10-01-00 serves as the primary 330104 Proximity Probe utilized to execute non-contacting shaft displacement and vibration measurements across 3300 XL platforms.

Hardware Option Breakdown

• 330104: 3300 XL 8 mm proximity probe mechanical housing template with flexible armor.
• 00: Designates a 0 mm unthreaded sleeve option profile.
• 05: Allocates a 50 mm minimum overall threaded case length configuration.
• 10: Establishes a 1.0 meter (3.3 feet) total hardware cable length parameter.
• 01: Equips a miniature coaxial ClickLoc connector along with a pre-installed connector protector on standard cable.
• 00: Denotes hazardous location agency approvals are not required.

Technical Performance Indexes

Signal Scaling and Cross-Talk Suppression

The 8 mm sensing tip relies on automated eddy-current probe scaling to transform magnetic field variations into linear voltage changes. The geometric configuration generates consistent radio frequency field interactions, supporting real-time tracking of rotor dynamics while maintaining high cross-talk suppression between adjacent channels when mounted within shared bearing housings.

Logistics Packaging Bill

• 1 x 330104-00-05-10-01-00 3300 XL 8 mm Proximity Probe with Armor
• 1 x Factory Integrated Coaxial Connector Protector Sleeve

Field Installation Protocols

• Thread Insertion & Locking
  • Advance the M10 x 1 threaded probe barrel into the sensor port slowly until reaching the proper clearance target.
  • Keep a minimum of 5 full thread engagements inside the mounting boss to withstand machine oscillation.
• Armored Conduit Routing
  • Route the 1.0 meter armored cable away from raw high-voltage motor supply conductors.
  • Maintain a minimum physical bending radius of 25.4 mm (1.0 in) along all physical support clamps.

Transducer Hardware FAQ

• What standard gap voltage validation target is required during baseline field calibration?

  The proximity loop relies on standard gap voltage validation targeting a nominal -10 VDC output position.

• How does the integrated armor layer alter the continuous physical routing bend radius?

  The stainless steel protective cladding enforces a strict minimum physical bending radius limit of 25.4 mm (1.0 in).

• Can this 1.0 meter probe module handle high-frequency mechanical vibration loops without data lag?

  Yes, the proximity probe runs an analog eddy-current loop providing direct physical execution with zero processing latency.

• What action occurs if moisture enters the miniature coaxial ClickLoc connector terminal junction?

  Moisture changes line impedance, degrading eddy-current probe scaling accuracy and generating false error signals.

• Is external cooling required when operating the sensor tip near high-temperature journal bearings?

  No, the passive transducer elements safely operate up to +177 deg C under normal convection conditions.

• Can this standard version transducer be mixed with specialized 3300 XL NSv series Proximitors?

  No, the 8 mm standard series possesses different tuning and cannot match with NSv series specific Proximitor components.

• What is the specific mechanical purpose of the factory installed connector protector sleeve?

  The connector protector isolates the coaxial link from touching machine grounding points, stopping ground loop noise.

• What consequence develops if the internal coil path is over-torqued during bracket mounting?

  Exceeding maximum torque limits deforms the internal wire structures, causing permanent loss of transducer calibration.