The Omron E5CC-RX2ADM-800, also cataloged as the E5CC Digital Temperature Controller, operates as a dedicated hardware component for closed-loop thermal process feedback and relay execution within automated panel networks.

Model Nomenclature & Part Number Breakdown

• E5CC: Panel-mount standard enclosure series (48 x 48 mm DIN size)
• RX: Control Output 1 relay output (SPST-NO), Control Output 2 unpopulated
• 2: 2 auxiliary relay outputs for system alarms or event status signaling
• A: Operating line power supply option rated for 100 to 240 VAC
• D: Low-voltage power supply configuration operating on 24 VAC / 24 VDC
• M: Universal input processing circuit supporting thermocouple, RTD, voltage, and current loops
• 800: Terminal block option variant designated for standard industrial wiring profiles

Electrical & Operational Specifications

Network Protocol & Deterministic Execution

The unit integrates internal logic execution supporting firmware flash compatibility for persistent parameter setup without non-volatile data corruption. High-density I/O routing inside the compact housing ensures deterministic response cycles during PID auto-tuning loops, enabling seamless field bus connectivity with programmable logic controller architecture across EtherNet/IP and Profinet networks via industrial interface gateways.

Scope of Delivery & Package Manifest

• 1 x Omron E5CC-RX2ADM-800 Temperature Controller unit
• 2 x Panel mounting side brackets
• 1 x Terminal cover protective shroud
• 1 x Technical installation guide sheet

Wiring Protocol & Enclosure Installation Guidelines

• Panel Cutout Mounting

  Cut out a standard 45 x 45 mm square panel opening. Insert the controller housing from the front side and clamp it using the supplied mounting brackets until sealed against the front rubber gasket.

• Terminal Screw Tightening

  Secure field conductors using M3 crimp terminals. Apply a tightening torque of 0.43 to 0.58 N.m to avoid thread stripping on the rear terminal block.

• Sensor Signal Wiring

  Route low-level sensor input wiring separately from AC power feeds and motor drive cables. Maintain proper 1:1 direct connection when interfacing with ES2-HB/THB sensors.

Frequently Asked Questions

• What supply voltage range does the E5CC-RX2ADM-800 controller accept?

  The unit operates on 100 to 240 VAC (50/60 Hz) or 24 VAC / 24 VDC within an allowable operating window of 85% to 110% of rated voltage.

• What control algorithms are available within the internal microprocessor?

  The controller supports selectable ON/OFF control or 2-PID control modes featuring integrated auto-tuning functionality.

• What is the maximum load resistance for the linear current output circuit?

  When linear current output is utilized, the unit drives 4-20 mA DC or 0-20 mA DC signals into a maximum load impedance of 500 ohms.

• What input impedance values apply to analog current and voltage sensors?

  Current input channels exhibit a maximum input impedance of 150 ohms, while voltage input channels present a minimum impedance of 1 Mohm.

• What primary control switching mechanism is present on Control Output 1?

  Control Output 1 utilizes a electromechanical relay (SPST-NO) rated for 250 VAC at 3 A under pure resistive loads.

• What connection precaution is required when using ES2-HB/THB humidity/temp sensors?

  When wiring ES2-HB or ES2-THB sensor assemblies to the high-impedance voltage input terminals, a strict 1:1 direct connection topology must be maintained.

• What resolution does the internal linear analog conversion stage provide?

  The linear current output processing circuit maintains a resolution rating of approximately 10,000 steps across its output span.

• What is the total unit weight of the physical panel controller?

  The instrument weighs approximately 0.13 kg, making it lightweight for high-density panel DIN cutout installations.