The Bently Nevada 106765-30, also cataloged as the 106765-30 Velomitor XA Sensor Interconnect Cable, operates as a dedicated connection component for velocity signal transmission between 330500 and 330525 Piezo-Velocity Sensors and monitoring systems.

Model Identification

Hardware Configuration

The 106765-30 cable assembly is designed for electrical interconnection between a Velomitor XA piezo-velocity sensor and the associated vibration monitoring input circuit. The cable uses two 22 AWG conductors and provides shield isolation for vibration signal transmission.

The cable construction supports signal integrity requirements for vibration measurement circuits where low capacitance and controlled resistance are required. The assembly is specified with a 30 m overall length for remote sensor installation configurations.

Technical Characteristics

Bently Nevada vibration monitoring systems use dedicated sensor interconnect cables to maintain velocity signal quality between field sensors and monitoring hardware. The 106765-30 provides conductor-to-shield isolation of 1500 VDC and controlled electrical characteristics for Velomitor XA sensor applications.

The cable installation should maintain proper shielding practices to reduce electromagnetic interference and prevent unwanted signal coupling. Correct cable routing supports stable vibration waveform transmission for rotor dynamics analysis and machine condition monitoring.

Ordering Information

• 1 x Bently Nevada 106765-30 Velomitor XA Sensor Interconnect Cable
• Cable assembly length: 30 m
• Sensor compatibility: 330500 and 330525 Piezo-Velocity Sensor series
• Conductors: 2 x 22 AWG cable construction

Field Installation Guidelines

Cable Routing

• Install the cable away from high-current power conductors and switching sources.
• Avoid sharp bending or mechanical stress on the cable jacket.
• Maintain separation from electromagnetic noise sources.

Shield Connection

• Connect the cable shield according to the monitoring system grounding requirements.
• Verify conductor insulation before final sensor connection.
• Keep cable termination points clean and protected from moisture contamination.

Frequently Asked Questions

• What sensor series is compatible with the 106765-30 cable?

  The 106765-30 cable is specified for connection with Bently Nevada 330500 and 330525 Velomitor XA Piezo-Velocity Sensors.

• What is the total length of the 106765-30 cable?

  The cable assembly has an overall length of 30 m (98 ft) for remote sensor installation applications.

• How many conductors are included in this cable?

  The cable contains two 22 AWG conductors designed for velocity sensor signal transmission.

• What is the operating temperature range of the cable?

  The specified operating temperature range is -40 deg C to +85 deg C.

• Does the 106765-30 cable require external power?

  No. The cable is a passive interconnect component and does not consume electrical power.

• What isolation rating is provided between conductor and shield?

  The cable provides 1500 VDC isolation between conductors and the cable shield.

• What electrical property affects signal transmission quality?

  Cable capacitance and DC resistance values influence signal integrity in vibration measurement circuits.

• Can the cable be installed near power cables?

  Installation near high-current power cables should be avoided to reduce electromagnetic interference effects.