The Omron 3G3MX2-A4030-ZV1 serves as the primary 3G3MX2 Multi-Function Compact Inverter utilized to execute pulse-width modulated frequency control and dynamic motor torque regulation across MX2 Series drive platforms.

Part Number Code Structure

• 3G3MX2: Base inverter chassis architecture identifier.
• A: Panel-mounting structure (IP10 minimum / closed wall-mounting type).
• 4: 3-phase AC 400 V supply voltage class (380 V to 480 V operational range).
• 030: Maximum applicable motor capacity of 3.0 kW (Continuous Torque rating).
• ZV1: Designated software/functional variation index.

Physical & Electrical Data Specifications

Deterministic Industrial Bus Synchronization

The internal logic structure incorporates high-speed backplane bus communication interface capabilities to coordinate deterministic network timing over EtherNet/IP and Modbus networks. Integrated firmware flash compatibility guarantees deterministic I/O scan cycles and rapid parameter updating without introducing data transmission latencies during full-duplex network communications.

Component Package Contents

• 1 x Omron 3G3MX2-A4030-ZV1 inverter unit
• 1 x Quick instruction manual and terminal connection diagram

Site Mounting & Terminal Wiring Guidelines

• Mounting Orientation

  Fix the inverter vertically onto a rigid metallic cabinet panel to guarantee unimpeded heat dissipation along the heat sink channels.

• Spacing Limits

  Maintain a minimum clearance of 100 mm above and below the drive frame, plus 10 mm lateral spacing between neighboring devices.

• Shielding & Grounding Terminations

  Clamp shielded motor output lines using a low-impedance copper cable gland directly to the panel earth bus to suppress high-frequency electrical noise.

Technical FAQ

• What is the nominal input supply voltage for the 3G3MX2-A4030-ZV1?

  The drive operates on a 3-phase AC power line rated from 380 VAC to 480 VAC at 50/60 Hz line frequency.

• What output current does this drive deliver at the 3.0 kW CT rating?

  Under continuous torque operation, the drive supplies up to 7.2 A of rated output current to the motor terminals.

• What degree of physical enclosure protection does the unit feature?

  The unit complies with IP10 enclosure guidelines and must be installed inside an industrial cabinet rated IP54 or higher.

• Can line power or motor cables be disconnected while energized?

  No, live terminal disconnection causes electrical arcing, which damages the internal IGBT inverter stage and internal logic circuits.

• How should analog speed reference signals be cabled?

  Analog 0-10 VDC and 4-20 mA command wires require twisted-pair shielded cables grounded strictly at the drive ground terminal.

• What heat dissipation measures are required during panel assembly?

  The drive relies on forced air convection, requiring unobstructed airflow paths across the rear extrusion heat sink assembly.

• What does the ZV1 code suffix indicate on the drive label?

  The ZV1 designator identifies a specific factory software parameter set intended for standardized system software integration.

• What is the permissible operating temperature envelope for this model?

  The unit operates reliably between -10 deg C and +50 deg C in ambient environments free from dripping water or corrosive gases.