Product Overview

The Bently Nevada 330103-00-06-15-02-00 is an extension cable used in the 3300 XL 8 mm proximity transducer system to connect the proximity probe to a compatible Proximitor sensor. In eddy-current measurement systems, the cable is part of the calibrated signal path, so correct selection helps maintain measurement stability for shaft vibration and shaft position monitoring.

This cable is intended for industrial installations where consistent impedance control and secure connector engagement are required to minimize signal loss and intermittent faults. When installed and routed correctly, it supports reliable machinery protection and condition monitoring performance across rotating equipment fleets.

Hardware Parameters

Additional engineering notes

• The 3300 XL proximity system calibration depends on the total electrical length of the probe + extension cable + Proximitor. Confirm system matching before replacement.

• Avoid tight bends and unsupported cable runs near the probe head to reduce mechanical stress and signal intermittency.

Industrial Applications

Typical uses include:

• Steam and gas turbines where proximity probes are used for radial vibration or thrust position measurement

• Centrifugal compressors in oil and gas service where stable displacement signals support protection logic and diagnostics

• Large pumps and motor-driven trains where trending vibration helps reduce seal and bearing failures

• Packaged equipment skids where field cable management and connector security are critical for uptime

Installation considerations

• Route away from high-current conductors and VFD outputs where possible to minimize electrical noise coupling

• Verify connector lock engagement and continuity during commissioning

• Perform loop checks and channel verification in the monitor system after cable replacement